Full video walkthrough
Step-by-step guide
1Calibrate the Initial Level
Draw a ruler over a known length and enter its real measurement. This sets the scale for your initial level.
You can calibrate at any time, but we strongly recommend getting the scale right at the start.
Toolbar → Calibrate
2Add Levels
Add a level above or below your existing floors. Upload a new blueprint, or select an area of an existing blueprint to move to the new level.
Level selector → Add Level
3Calibrate the New LevelOptional
Once the new level is ready, use a calibration ruler to set its scale.
Skip this step if the new and initial blueprints use exactly the same pixel scale.
Toolbar → Calibrate
4Align Floor Plans
Mark matching points on the floor plans, such as the same building corner. Use them to line up the levels when stacked.
Floor Tools → Align Floor Plans
5Align Walls Across Levels
Use Overlay to compare the new level with the initial level.
Turn on Detect Coincident Points, then adjust matching wall points until they line up.
Show Reference Levels → Overlay
6Edit Elevation AreasOptional
Divide a level into areas if parts of its floor sit at different heights.
Skip this step if the entire level has one floor height.
Floor Tools → Edit Elevation Areas
7Adjust Floor Elevations
Set the floor heights and slab thicknesses to match your building.
Floor Tools → Adjust Floor Elevations
8Add Pin & Socket Connections
Add matching pins and sockets between floors. They help the printed levels line up and stay together during assembly.
Floor Tools → Pin & Socket Connections